国产精品自产拍在线观看首页_国产美女遭强高潮开双腿_亚洲日本文字天天更新_国产美女高潮久久久久白浆,国产精品亚洲一区二区三区天天看|久久久综合九色综合|欧美日韩精品视频一区二区在线播放|亚洲小视频在线观看

I. status of floating fiber

In the production of glass fiber materials, the simplest appearance is poor, mainly scorched and exposed fiber, and material flowers.

II. Cause analysis of floating fiber:

1. Mold: during glue injection, the activity of material is the activity method of melt. With the introduction of glass fiber, the mobility of glass fiber is much worse than that of plastic. However, the movement of plastic in the mold flows forward from the middle of the interlayer and the two sides turn outward. Therefore, PP with good mobility is in front of the melt, while those with poor mobility will stay on the surface of the mold.

Solution:

A. add glue injection speed to reduce the speed difference caused by viscosity difference. Under the condition of high-speed injection, the relative velocity difference between slow moving glass fiber and fast moving plastic decreased significantly;

B. increase the mold temperature, reduce the touch resistance between glass fiber and mold, and minimize the speed difference between glass fiber and plastic. And let the middle of the plastic be as thick as possible and the shell on both sides be as thin as possible;

C. reduce the measurement temperature, reduce the amount of sol, and minimize the possibility of separation of plastic and glass fiber;

2. Materials: the viscosity of PP, PA and other resins shall be as low as possible within the range permitted by mechanical properties, and the glass fiber shall be as short as possible. If PA66 is used, an appropriate amount of PA6 shall be added to add mobility;

3. Processing technology: A. properly improve the screw shear force; b. Increase the injection speed, and the screw speed can be adjusted to 70%-90%; c. Increase injection pressure; d. The whole screw is retracted by 1-2mm to avoid floating fiber in the gate; e. Graded injection molding is adopted for disordered parts.

4. Additives: it is the most effective way to improve the activity of glass fiber and enhance the bonding ability between glass fiber and resin, such as adding some additives such as silicone and dispersant.

Source: Jiangmen engineering plastics http://www.lyx0.com/